Car Lock Type

c

Transponder Type

c

Turbo Decoder for VAG-Group HU66

6600

New

More info

Buy only from trusted seller!

100% Oryginal Product

The Turbo Decoder for VAG-Group HU66 locks is a new generation tool which will allow you to open and ignite your car in a short time, without damaging the lock. Thanks to this tool you will be also able to read the lock code and reproduce the key in case you lost it.

It works with the following VAG-Group cars:

VW, Audi, Skoda, Seat, Porsche 
VW models from 2001 to current 
Audi models from 1996 to current 
Seat models from 2001 to current 
Skoda models from 2001 to current 
Porsche models from 2001 to current

Video

How to use the Turbodecoder:

1 Setting up the Turbodecoder

-close the gate wheel

-turn the line (turbo wheel) next to the point (gate wheel)

-open the gate wheel

-rise the pins open to the maximum position

-close the gate wheel

-turn the line (tension wheel) maximum to the right

2 Checking the generation of the lock by using the Keytester in order to later put in the decoder with the proper side

-we put the keytester in the lock: if it stops on nothing you just reverse the key, then if it stops on green it means that the lock is second generation type. If it stops on red it means that it is a first generation lock. After correct putting it in, check the direction of the points.

3 Putting the Turbodecoder in

Close gate wheel

Turn turbo whell maximum to the right

Put the Turbodecoder in with a closed gate, and holding the gate wheel with points directed to the same side as the keytester pointed.

4 Starting to open the lock

to open a lock very important is how strong you make a tension. (tension wheel)

too weakly – do not open a lock

too strong – break a tool

-while opening VAG group car locks first make 2-3 empty pumps: holding the tension wheel turn turbo wheel maximum to the left and then maximum to the right. Repeat it 2-3 times

-turn the turbo wheel right and open the center gate wheel

-make a tension left (turn the tension wheel left) and turn the turbo wheel on line number 1 (turn the turbo wheel to the first line on the gate) and return the turbo wheel right and juggle a little bit

-make a tension right (turn the tension wheel right) and turn the turbo weel on line number 1 (turn the turbo wheel to the first line on the gate) and return the turbo wheel right and juggle a little bit and conversely repeat it 4-5 times from 1-1, 1-1, 1-1, 1-1 then 2-2, 2-2, 2-2, 2-2, and progressively so on, until you open the lock

-when the turbodecoder is turned to the open position stay in this position and turn the turbo wheel to the point on the gate wheel

-juggle a little bit

-turn to the other side

-juggle a little bit

5 Take off torbodecoder

-put the line (turbo wheel) next to the point (gate wheel)

-moving the gate wheel up and down push the gate at the same time until you close it

-turn to the right (turbo wheel)

-extract the tool holding the tension wheel

6 Reading code

-open the gate

-turn the line (turbo wheel) next to the point (gate wheel)

-check the pin depts on the tool and write them down on a piece of paper

All information on the use and handling this product are contained in the ruleswhich the buyer is obliged to acknowledge that he is familiarwith their content and accept them before purchasing.